Question 1

Does the suction cup hold well?

Accepted Answer

Yes. It uses a high-quality 30mm suction cup that grips the glass securely, so the holder stays in place on the windscreen.

Question 2

Will it block the RFID signal at the toll?

Accepted Answer

No. The acrylic is clear and non-metallic, so it does not interfere with RFID reading. Your tag still scans normally at toll gantries.

Question 3

Does it work on tinted windshields?

Accepted Answer

Yes, it works on both tinted and non-tinted windshields. It mounts on the inside of the glass with the suction cup.

Question 4

Can I remove or reposition it later?

Accepted Answer

Yes. Because it uses a suction cup and no glue, you can reposition or remove it any time without leaving residue, and even move it to another car.

Question 5

How is this better than sticking the tag directly on the glass?

Accepted Answer

Sticking the tag straight onto the glass is hard to remove and can leave residue. This holder keeps the tag mountable, removable and protected, with a clean laser-cut finish.

Question 6

What is it made of?

Accepted Answer

It is laser-cut from clear acrylic with precise edges for a neat, polished look, and it helps protect the RFID tag from direct handling.

Question 7

Where is it made and how is it delivered?

Accepted Answer

It is made factory-direct by UMAKE in Balakong, Selangor and ships nationwide across Malaysia. Order via WhatsApp to confirm delivery time and any bulk pricing.

Acrylic Car RFID Holder (Suction Cup)

数量